Warning: Safety Precautions - Remington Powerdriver 490 Instrucciones De Operación

Warning: Safety
WARNING ICON G 001
The following pages contain detailed warnings, cautions, and
rules of safe operation. Read carefully and become familiar
before operating to avoid serious injury. We expressly disclaim
any liability for any injury to persons or damage to property
which result from your failure to take the precautions contained
in this manual.
WARNING: This tool is designed only for use by qualified
WARNING ICON G 001
operators. Qualification is obtained through a thorough under-
standing of the Safety Precautions and operating instructions
as defined in this operating manual. NOTE: The labor regula-
tions of many states require that the operator of this tool on a job
site be thoroughly trained and certified for competence prior to
operating this tool. For certification procedures, call: DESA
Specialty Products™ Technical Services Department, 1-800-
858-8501 or visit www.desatech.com.
BEFORE USING
1. ALWAYS handle the tool as if it were loaded. Before starting
work, check that the tool is unloaded and the muzzle is clear.
NEVER load a tool unless it is going to be used.
2. ALWAYS inspect to make sure the tool is working properly.
If the tool does not work properly, remove from service and
tag DEFECTIVE. DO NOT use the tool again until it has
been properly repaired.
3. Operators and bystanders must ALWAYS wear goggles
and ear protection which meet or exceed ANSI standards.
101274
Precautions
?
489-03
489
489-07
?
3
489-04
489-06
489-08