I Nstallation Standards; Device Fixed To The Bracket; Rigging Installation; Connected Devices - Mark BEAM 190 Instrucciones De Usuario

EN
3. Before power on, make sure you have opened the X, Y axis lock!
4、INSTALL STRANDARD
4.1 INSTALL LOCK
BEAM 190 can be placed on the stage, or mounted in an arbitrary direction of the truss. Two fast
locks system could fix the item easily .
4.2 EQUIPMENT FIXED
1. Before installation must verify the fast lock is keep in good state, and can withstand at
least 10 times the weight of product. V erify that the building can withstand at least 10
times of the total weight of the product and accessory equipment s.
2. Fix the hang fixture into the hole, which located on the base of the price.
Seize handle of fasteners , clockwise rotat e 1/4 turn and lock. Installed other one fastener
in the same method .
3. Using the safety cable which can withstand 10 times the weight of the equipment
4. Make sure the X,Y prote ct locks are opened, Verify that within 3 meters there is no
combustibles .
WARNING
Fixture must use two fixing devices, and make sure the fixing device have locked! And only
full y clockwise rotat e 90 ° can lock the hang fixture! Do remember plus a safet y rope, and
do not connect the safety rope to plastic handle. It should be connect to the hole on the base!
4.3 FIXTURE CONNECT
If use the DMX512 splitter. At first connect DMX512 Splitter input terminal to
controller .And then connected from the splitter output terminal to next device.
BEAM 190
Attention! One product only can accept one input one output
BEAM 190 DMX cable include 3 contact pins:
Pin 1, FOR GROUND; Pin 2 connected to the negative polarity signal; The pin 3
connected to the positive polarity signal.
DMX512 cable must use the professional shielded twisted pair cable ; standard
loudspeaker cable is not reliable to control the long-range data. 24AWG cable is
suitable for more than 300 meters long-distance signal transmission and must add \
DMX 512 signal amplifier.
Do not use two outputs to separate the connection, if separate a continuous connection
to branch , DMX512 splitter is necessary .
User Manual/Manual de uso
.
.
Pag 8