Packing And Shipping; Packaging Randomized Accessories Project; Transport The Protection Locks; Device Packaging - Mark BEAM 190 Instrucciones De Usuario

5.
Fan or ventilation, at least in the range of 0.5 meters can not be an obstacle
6.
Do not place any object on the lens
7.
Handling at least allow the device to cool for 20 minutes
8.
Do not replace the non -original parts.
. PACKAGE
3
3.1 ATTACHMEN T
BEAM 190 packed with fly -case of one in one ,two in one ,or carton box.
Attach follow accessory.
ACCESSORY
CONTENT
USER MANUL
HANG FIXTURE
SIGNAL CABLE
PACAKGE SIZE
CARTON BOX
FLY-CASE 1 IN 1
FLY-CASE 2 IN 1
3.2 TRANSPORT PROTECT LOCK
In order to protect the light, there is a protect lock; During the transport , the lock will closed
keeping the item in safety state.
3.3 ABOUT PACK STAGE
1. Before packe d, make sure power is off, and wait for at least 20mins for cooling down.
2. Before clean the fixture, make sure X, Y axis protect lock closed.
3. After packed by plastic
the product into the fly-case up - side -down.
4. After packed the product, put the accessory into the accessory case, then closed and lock the
fly -case.
5. Fly-case only u p stacked two layers. Prohibited upside down
6. When packed with carton box, equipment should be put into the foam first , then set into a
carton, pay attention to the vertical position.
3.4

UNPACKING

Note: Before unpacking check the damage is whether due to the transportation or not , if you
find any such damage, please do not use this item, and cont act with the dealer or manufacturer as
soon as possible.
1. Open the flycase, and discover the inside plastic bag.
2. High-lift the product by two handles beside the bottom base and move it out.
BEAM 190 User Manual/Manual de uso
.
QUANTITY
1 piece
2 pcs
1 piece
37×42×56cm
44×47×72cm
82×47×72cm
bag, highlift the fixture with two handles besides the product. put
.
.
Pag 7
EN