Topping Up The Charcoal - FLORABEST FLG 34 C1 Manual De Instrucciones E Indicaciones De Seguridad

FLORABEST FLG 34 C1

Season the food and turn it occasionally. We recommend the use of wooden barbecue tongs. You
can also brush fish with butter.

At the top fan speed, the charcoal barbecue heats up very quickly. Keep an eye on thin pieces of
food and sausages to stop them burning. Turn it frequently or turn the fan speed down.

The charcoal barbecue develops the most heat in the centre. Put bread on the edges to toast it. Put
thick slices of meat in the centre to cook.

Do not grill pickled or smoked meat.

Cut any charred or burnt pieces of food off and do not eat them. Also, make sure you do not drip
any beer on meat or sausages. Crusts and burnt bits can be carcinogenic!

Cut the fat from the edge of the meat and, for best results, only use lean meat cut into small pieces. If
the fat ignites and flames appear, turn the control dial (9) counter-clockwise to the "OFF" position
and take the meat from which the fat is dripping off the stainless steel grate (1). Once the flames
have disappeared, you can increase the fan speed again using the control dial (9) and place the
food back onto the grate. Do not extinguish the flames with water.

7.4 Topping up the charcoal

You can top up the charcoal if necessary. It is best to do this before the charcoal in the charcoal container
(4) is used up. This means the new charcoal can be kindled from the existing embers.
Risk of burns!
Always wear barbecue gloves to top up the charcoal. Otherwise you could get burnt.
Warning about property damage
Only put the charcoal container (4) and its cover (3) on heat-resistant surfaces. Otherwise, the
surface could be damaged by these hot accessories.
1. Switch the charcoal barbecue off if you wish to top up the charcoal. Turn the control dial (9) counter-
clockwise to the OFF position, until it engages.
2. Remove any remaining food from the stainless steel grate (1).
3. Loosen both latches (7) and remove the stainless steel grate (1). Place the stainless steel grate (1) on
a suitable surface.
4. Remove the cover of the charcoal container (3). It is best to do this with barbecue tongs and always
wear barbecue gloves. Otherwise you could get burnt.
5. Place the cover of the charcoal container (3) on a suitable surface.
6. Add the new charcoal to the charcoal container (4). When you do so, make sure that you do not
overfill the charcoal container (4) so that you can close it again once you have finished.
40 - English