The Cell; The Connection Cables; Installation - Monarch Eco-MATIC-ESR Serie Manual De Instalación Y De Mantenimiento

2.2) T C
HE ELL
The cell body is transparent so as to make it easier to check the electrodes for dirt. The
electrodes, which are made of special materials, are used to electrolyse the water in the
pool.
2.3) T C
HE ONNECTION
These have the following functions:
- to connect the switch cupboard to the output of the filter unit power supply unit
(230V single phase + earth);
- low voltage supply to the cell;
- connection of the safety device.
Electrical Characteristics:
Max. Power

3) INSTALLATION

 The unit should be installed by a professional and in accordance with current
accepted practices (IEC Standard 364-7-702 and NFC 1500 Section 702).
The power supply should include electrical protection and isolating gear in
accordance with the regulations in force.
See General Installation Diagram, Appendix 1 - Paragraph 9.
 First select a place inside the plant room where you can fix the switch cupboard at a
height at which it can be accessed and read easily.
 Connect the control unit in parallel with the filter circuit pump such that the unit only
starts when the pump is in operation.
C
ABLES
230V – 50Hz
IP 33
3A HBC fuse
ESR 160 = 160 W (0.8 A)
ESR 240 = 240 W (1.2 A)
ESC 16 = 100 W (0.5 A)
ESC 24 = 150 W (0.75 A)