BIO-CIRCLE TECHNICAL SUPPORT
Should you have any trouble with the operation of your BIO-CIRCLE Parts Cleaning System,
please refer to the section "TROUBLESHOOTING".
Should you require further assistance:
Canada: CALL TOLL FREE 1-877-BIO-DRUM (1-877-246-3786)
USA: CALL TOLL FREE 1-888-246-2725
Mexico: CALL TOLL FREE 01 800 263 6310
Visit us at: www.biocircle.com for additional information.
WARRANTY POLICY
All BIO-CIRCLE™ Parts Cleaning Systems and accessories are inspected and tested before shipment
and are warranted to be free from any defect in material and faulty workmanship. Should any
malfunction occur within one year from the date of original purchase please call WALTER SURFACES
TECHNOLOGIES (see page24 for additional contact information).
Should a component examination reveal that the malfunction was caused by defective material or faulty
workmanship, WALTER SURFACES TECHNOLOGIES will repair (or at our option, replace) without
charge. This warranty does not apply when; normal maintenance is required, repairs or replacements
have been made or were attempted by anyone other than WALTER SURFACES TECHNOLOGIES
authorized service personnel, and does not cover any damage caused by accidents, modifications, use
of improper solutions, accessories, abuse or misuse as well as continued use after partial failure. No
other warranty, written or verbal is authorized.
In no event shall WALTER SURFACES TECHNOLOGIES be liable for any indirect, incidental or
consequential damages from the sale of the product. This disclaimer applies both during and after the
term of this warranty.
This warranty gives you specific rights. The provisions contained in this warranty are not intended to limit,
modify, take away from, disclaim or exclude any warranties set forth in any provincial or state legislation.
To the extent required by law, the provisions in any provincial, state or federal legislation with respect to
warranties take precedence over the provisions in this warranty.
21
20