Safety Instructions - Walter Bio-Circle Maxi 55D600 Manual Del Usuario

SAFETY INSTRUCTIONS

BIO-CIRCLE™ Parts Cleaning Systems are produced in accordance with
applicable standards governing the manufacture, performance and safety
of industrial products.
WARNING: Before using this machine, read all safety and operating instructions
carefully and save this owner's manual for future reference. When using this
parts cleaning system, basic safety precautions should always be observed to
reduce the risk of fire, electric shock and personal injury, including the following:
1. Read this owner's manual to familiarize yourself with the unit's operation, its
particular features, applications and limitations.
2. Parts that are damaged or otherwise defective should be repaired or replaced.
3. Adequate ventilation should be provided when operating the unit. Keep work
areas clean. A cluttered environment invites accidents.
4. Keep children and other persons at a safe distance from the work area. Do
not let unqualified persons handle this machine.
5. Your BIO-CIRCLE™ machine is equipped with a magnet inserted underneath
the grated receptacle in the sink. Always handle it with care, as it will shatter if
dropped and may cause injuries. Keep magnet away from electronic devices
and magnetic media such as floppy discs, credit cards and computer
monitors. Keep magnet away from pacemakers.
Do not contaminate the cleaning solution with any flammable or
combustible substances such as gasoline, alcohol, mineral spirits,
solvents etc. Drain parts to be cleaned of any flammable or
combustible material before placing them into cleaning sink. Even
small quantities can create a fire hazard. Please refer to the
information provided on page 2 (Two) which describes the solutions
appropriate for use in the 55D600. Do not introduce into the unit any
cleaning solution other than Bio-Circle™ L, Bio-Circle™ Ultra, and
Bio-Circle™ Aero.
6. Using other cleaning solutions will cause malfunctions.
Bio-Circle
7. The
coil, the circulation pump and the heater coil must always be immersed.
Failure to keep the proper level inside the machine can cause critical
damage to the pump and/or over- heating the heater coil thereby creating a
potential fire hazard. To help prevent this, the 55D600 unit is equipped with
a liquid level sensor and a high temperature limit switch, which will shut off
the pump and the heater coil when the liquid level is low.
8. CAUTION: Used cleaning solution may be irritating to skin and eyes. While
working, always wear appropriate gloves and approved safety goggles.
9. First Aid: If used cleaning solution is splashed on clothing, change promptly.
Thoroughly wash anybody areas that have been in contact with the solution.
Saturated clothing must not remain in contact with skin.
TM
MAXI
(55D600) Parts Cleaning System includes a heater
3