Touch Screen Calibration (For Windows Xp, Windows Vista, Windows 7) - LG T1710BP Manual De Usuario

Touch Screen Calibration (For Windows XP, Windows Vista, Windows 7)

1
Select the touch device and display monitor connected to the PC with a mouse under "Touch Device" and
"Display Monitor" respectively. (Check)
2
Set the display resolution for Display Monitor to the maximum supported resolution (optimum resolution).
- Maximum supported resolution (optimum resolution) for T1710BP: 1280 X 1024
- Maximum supported resolution (optimum resolution) for T1910BP: 1280 X 1024
3
Click the Calibration button.
4
When the calibration screen appears, calibrate in the order shown in the figure below.
1
4
1) Using a stylus pen or fingertip, press the center of the touch point for a few seconds. After a few
seconds, the touch point turns red > yellow > green ("TOUCH" -> "HOLD" -> "LIFT OFF"); calibration for
pointer 1 is then complete.
2) Repeat the same procedure for all five touch points. (1 > 2 > 3 > 4 > 5 in order)
3) When the calibration for all five touch points is complete, the screen automatically disappears.
4) After the initial calibration, the values are automatically saved; further calibration is not required.
5) To cancel the calibration process, press ESC to return to the stage prior to calibration.
CAUTION
if calibration is performed incorrectly, the screen may fail to recognize the correct coordinates. If the
y y
touch screen's coordinates are not aligned properly, recalibrate.
2
5
3
TOUCH SCREEN OWNER'S MANUAL
7