Polk Audio TSx Serie Manual Del Usuario página 4

Take Inventory
Inside each speaker container, you should find the following:
1.
One TSx floorstanding speaker, two bookshelf speakers
or one center channel speaker
2. TSx manual
3. Registration card
4. Adhesive-backed rubber pads—(8 for bookshelf
speakers or 4 center channel speaker)
5. Wall mount template (for TSx110
Important Note: If anything is missing or damaged, or if your
speaker fails to operate, notify Polk Customer Support
Services immediately at 800-377-7655.
Speaker Location
(550 , 440 , 330 , 220 & 110
t t t b b
Left
Create an equilateral triangle between the speakers and the listening
position. Toe-in to your listening preference. If you notice video distortion
or discoloration, immediately move the speakers away from the video
source and call Polk Customer Service 800-377-7655 (US and Canada)
or polkcs@polkaudio.com.
Using Binding Post Connections
1. Loosen hex nut.
2. Insert speaker wire through hole.
3. Tighten hex nut.
4. Do not insert insulated section
of speaker wire.
To use Banana Plugs (US only):
Carefully pry out the binding post
plugs to expose banana plug holes.
(This is for US owners only.)
Please observe the proper polarity
One of the terminals on the rear of the speaker is marked red (+) and
the other black (–). Make certain that you connect the wire from the
red (+) terminal of your receiver or amplifier to the red (+) terminal on
your speaker, and the wire from the black (–) terminal of your receiver
or amplifier to the black (–) terminal on your speaker. Most wire has
some indication (such as color code, ribbing, or writing) on one
of the two conductors to help maintain consistency.
4 Polk Customer Service 1-800-377-7655 (Outside US: 410-358-3600
bookshelf speakers only)
b
)
Right
1
3
Bi-Wiring
(550 , 440 & 330 )
t t t
Power Amplifier
Front
R
Bi-wiring, or using separate speaker wire connections for
high and low frequency sections. Remove flat metal jumpers.
Bi-Amping
(550 , 440 & 330 )
t t t
Low Frequency
Amplifier
R L
Bi-amping, or using separate amplifiers for the low and high
frequency sections of your speakers. Remove flat metal jumpers.
Basic Bookshelf and Center Speaker Hookup
(220 , 110 , 250 & 150
b b c
Power Amplifier
2
4
Set Bookshelf and Center Speakers to "small"
in your receiver's Bass Management settings.
Monday-Friday, 9:00 AM-5:30 PM Eastern Time
L
High Frequency
Amplifier
R L
)
c
polkcs@polkaudio.com