Instructions For Use; Adjustiment Steam - POLTI Vaporetto Go Manual Del Usuario

VAPORETTO GO - NA - 1U03:FEV 1000-950.qxd
INSTRUCTION FOR USE
• Vaporetto is now ready for use.
dispensing steam press button (1B). To start
dispensing again, press button (1B) in the
opposite direction and turn the steam request
command lever (1A).
The first jet of steam may contain some water
droplets, due to the hoses being colder than the
steam coming from the boiler; in a moment
steam will continuously flow from the unit. We
would therefore advise that the first jet of steam
is sprayed onto an old cloth until a constant
steam flow is obtained.
Note: The steam pressure indicator lamp (E)
may go on and off periodically during use of
Vaporetto, this is quite normal.
If you press the steam request lever (1A) when
the appliance is still under pressure, even if the
power is off and not connected to electricity, you
may still experience steam escaping from the
flexible hose.
When you switch off the appliance, before
storing it, it is neccessary to press the steam
request lever (1A) until the steam flow and
excess water are exhausted.
VAPORETTO GO
•Press the ON/OFF swit-
ch (C) (Fig. 5). The
power indicator light (D)
and the pressure light
(E) will turn on.
Wait for the pressure
green indicator lamp (E)
to go out (approx. 5 mi-
nutes).
• The steam sprayer
(1C) has a safety switch
(1B) that prevents
accidentally starting the
steam delivery by
children or people
unfamiliar with how the
appliance works. To
prevent accidentally
26/03/2014 17.20 Pagina 9
CONNECTION OF ACCESSORIES
• To release the accessories simply hold the
button (1D) down
components.
• Before using the accessories, make sure that
they are firmly in place.
se.
ADJUSTMENT STEAM
flow.
Here are some tips for regulating it:
• Strong steam: to remove scaling, stains,
grease and to sanitise;
• Normal steam: for carpets, rugs, glass,
floors;
• Gentle steam: to steam plants, clean delicate
fabrics, wall coverings, sofas, etc.
9
•To connect the
extension tubes (2) to
the steam gun, the large
brush (3) and the
adapter (4), simply join
them to one another
until the accessory
locking button (1D)
clicks into place.
and separate the
• To connect accessories
(5-6-7-8-9-10-11) the
adaptor must be
attached first (4).
Once the adaptor is atta-
ched, connected the ac-
cessory chosen, aligning
the arrows on them (Fig.
11), then turn it clockwi-
• Vaporetto enables the
flow of steam desired to
be optimised by turning
the adjustment knob
(G). To increase the flow
turn the dial anti-
clockwise.
Turning it in a clockwise
direction reduces the