Storing The Device; Care Of Your Appliance; Troubleshooting - POLTI Vaporetto Go Manual Del Usuario

VAPORETTO GO - NA - 1U03:FEV 1000-950.qxd

STORING THE DEVICE

PROBLEM
ON lamp (D) off
ON lamp (D) on but no steam
is delivered
The safety cap cannot be un-
screwed
VAPORETTO GO
• Store the unit by clip-
ping the end of the ex-
tension tubes into the
generator as shown he-
re.

TROUBLESHOOTING

Check that the plug is properly connected to the mains socket.
Ensure that the appliance has been turned on using the ON/OFF swit-
ch (C).
Wait for the Steam pressure indicator lamp (E) to turn on (approx. 10
minutes). If even once the lamp (D) is on, steam is still not delivered,
there is no water in the boiler. Fill according to the instructions given in
the manual.
Ensure the machine is off and disconnected from the power supply
and enable the steam control lever (1A) on the steam sprayer (1C) un-
til the steam flow ceases (paragraph "SAFETY CAP / SHORTAGE OF
WATER")
If the problem persists, unscrew the cap at the same time as applying
gentle pressure with fingers to the cap pin (see fig. A)
26/03/2014 17.21 Pagina 13

CARE OF YOUR APPLIANCE

• Before attempting
operation, make sure to always disconnect
the appliance from the electrical outlet.
• We recommend that the bristles of the brushes
are allowed to cool down in their normal
position after use, so as to avoid any mis-
shaping.
• To clean the body of the appliance, simply use
a moist cloth.
Regularly check the status of the red gasket lo-
cated in the moulded plug (1F). If necessary, re-
place it with the appropriate spare part (17) as
below .
- Remove the broken / damaged red gasket.
- Insert the new one. Put it on the steam nozzle
and push it until it rests in the groove.
- Lubricate the gasket with some vegetable oil.
SOLUTION
13
any maintenance
Fig. A