POLTI Vaporetto Go Manual Del Usuario página 13

VAPORETTO GO - NA - 1U03:FEV 1000-950.qxd
the surfaces to be cleaned. We recommend to
set the steam rate at the minimum level and
not direct the steam jet directly onto the sur-
face but cover the brush with a cloth.
Otherwise, clean them using a previously
steamed cloth.
• On particularly delicate surfaces (e.g. synthe-
tic materials, lacquered surfaces, etc.) it is re-
commended to always cover the brushes with
a cloth and set the steam rate at the minimum
level (if your appliance provides for steam re-
gulation).
• When cleaning glass surfaces in particularly
low temperatures preheat the glass holding the
steam gun at minimum 1.6 ft (50 cm) distance
from the surface to be cleaned.
• For the care of your plants, vaporize at a
minimum distance of 1.6 ft (50 cm).
USING THE STEAM GUN (1C)
• The more resistant the stain, the closer you
should hold the gun, the steam pressure and
temperature being higher at the source. You
should however always wipe with a dry cloth
(or a slightly abrasive sponge-if the spot is a
difficult one to remove) after using the gun.
• The steam gun is particularly efficient at:
- breaking down rug and carpet stains before
they are treated with the large brush;
- cleaning stainless steel surfaces, glasses,
mirrors, enamelled surfaces;
- cleaning hard-to-reach corners, such as
stairs, window sills, door posts;
- cleaning knobs of cookers, and water tap
bases;
- cleaning window shutters, heaters, car
interiors;
- spraying plants (from a distance);
- removing odors and creases from clothes.
• To reach higher points, the steam gun can be
connected to one or both extension tubes.
26/03/2014
VAPORETTO GO
• Use the large brush directly without the cloth
on particularly dirty or encrusted areas and in
spaces between the tiles: swing the large bru-
sh sideways to detach the dirt, then attach
cloth to large brush to pick up the dirt .
• On difficult corners or stubborn stains use the
steam gun and then wipe the treated surface
with a cloth.
• On vertical washable surfaces, wallpaper and
ceilings, fasten a dry cloth on the large brush
and proceed as for the floor. We advise to use
a cloth high-absorbent (e.g. an old bath towel).
• Vaporetto is ideal for cleaning hygienically both
synthetic and wool rugs as well as for most
• The steam gun types of carpet. Move the large brush towards
can be used di- your feet on the surface without the cloth to
rectly, without loosen the dirt, then fasten a cotton cloth to the
connecting the large brush, fixing it on the lever-type clasps
brushes, on all (3A), then wipe again the surface to pick up
spots requiring a the dirt in the cloth.
stronger, closer • Fold a cotton cloth over 2 or 3 times according
treatment. to the length and resistance of the pile. Move
the large brush rapidly on the pile without
applying any pressure, moving the large brush
to and from and laterally without concentrating
for a long time in the same place. The treatment
can be repeated as frequently as you wish over
time, as drying very quickly on most surfaces.
• In case of particularly dirty or full of detergents
pile, do not stay in one place for a long time;
the results will be evident after a number
applications of Vaporetto over time.
• Stubborn stains may require the direct use of
the steam gun (from a distance of 0.15 - 0.3 ft
(5-10 cm)) prior to the above indicated
treatment, then clean the stain with a cloth.
Can also be used as a steam lance. The lance
allows you to direct the jet of steam to the most
11
17.20 Pagina 11
USING THE LARGE BRUSH (3)
• To wash floors, put a clean, dry
cloth (15) under the large brush
and swing back and forth without
applying any pressure.
• Use the other side of the cloth
when the first one gets dirty.
ACCESSORIES SOCKET (4)
• Use this adaptor for connecting
the accessories (5-6-7-8-9-10-
11) to the steam gun or the ex-
tension hoses.