Raising The Mast/Load; Lowering The Mast/Load - TRUSST CT-CS60 Guía De Referencia Rápida

TRUSST® QRG

Raising the Mast/Load

1. Pull the top mast safety ring
2. Rotate to unlock the top section.
3. Turn the winch crank handle clockwise to lift the mast to the desired height.
4. Once desired height is reached, pull ring and rotate into one of the positioning holes on mast to
lock section.
5. Repeat steps 1-4 for the middle section, as well as the lower section.

Lowering the Mast/Load

1. Turn the winch crank handle slightly clockwise to release tension on the lower mast safety pin.
2. Pull ring and rotate to unlock the bottom section.
3. Turn the winch crank handle counter-clockwise to lower the mast.
4. Lower to desired height, pull ring and rotate into one of the positioning holes on mast.
5. Repeat for remaining middle and top sections.
Lower Mast
Do not use this Crank Tower in any way for which it was not intended.
Pinch Point! Keep hands and fingers clear of the galvanized steel cable while lifting or
lowering the mast.
Middle Mast
6
EN
Fully Closed CrankTower
Ready for Transport