Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTAllATION INST UcTIONS
cONNEcTiNG
ELEcTRic DRYERS {cont.)
USA ONLY
WARN|NG:
• Connect
the power
cord
to the terminal
block.
Each colored
wire should
be connected
to same
color
screw.
Wire color
indicated
on manual
is connected
to the same
color
screw
in block.
Failure
to follow
these
instructions
may result
in a short
or overload.
• Grounding
through
the neutral
conductor
is prohibited
for: (1) new branch-circuit
installations,
(2) mobile
homes,
(3) recreational
vehicles,
and (4) areas
where
local
codes
prohibit
grounding
through
the neutral
conductor.
Three-wire
Connection
for Electric
Dryers:
Power
Cord
• A 3-wire connection
is NOT permitted
on new
construction
after January 1, 1996.
A UL-Nsted strain relief is required.
Terminal
Block
UL-Listed
Strain Relief
3-Wire
Power Cord
Remove the terminal block access cover
on the upper back of the dryer. Install a
UL-Nsted strain relief into the power cord
through-hole;
then thread a UL-Nsted, 30A,
240V, 3-wire, #10 AWG-rninirnurn
copper
conductor
power cord through the strain
relief.
.....
jt
= Use a 30-amp,
240V, UL-listed
power
cord
with
#10 AWG=rninirnum
copper
conductor
and closed
loop
or forked
terminals
with
upturned ends.
.......
Hot
(Black)
(White)
(Red)
Attach the two hot leads of the power cord
to the outer terminal block screws. Attach
the neutral wire to the center terminal block
screw. Connect the external ground (if
required by local codes) to the green ground
screw. TIGHTEN ALL SCREWS SECURELY.
Reinstall the terminal block access cover.
21
Publicidad
Tabla de contenido
