Set-Up - Renaware Aqua 3000 LED Manual Del Usuario

SET-UP

Remove the Aqua 3 3000 LED from
the shipping box, remove packing
materials, and compare box contents
with the packing diagram. (Figure 1)
1. Unscrew the filter housing from the
base assembly by holding the
base securely and turning the
filter housing in a counter-
clockwise direction.
2. Remove the protective packaging
material from the CMF Cartridge.
IMPORTANT NOTE: This packaging
material must be removed and the
CMF cartridge inspected before
use to be sure the cartridge has
not become dislodged or damaged
during shipping.
3. After checking the CMF Cartridge,
screw the housing gently but firmly
back into the base. Do not over-
tighten.
4. Using padded or locking pliers,
remove the existing aerator from
your faucet. (Figure 2)
Figure 2
5. Remove the protective foam wrap
from the diverter valve assembly.
NOTE: There are two diverter valve
gaskets provided, however, only one is
needed.
Using the thick gasket first, thread the
diverter valve onto the faucet, "hand–
tighten" only. (Figure 3) Do not over
tighten as it could damage the threads.
If the diverter valve does not thread on
properly, unscrew and use the thinner
gasket.
Figure 3
NOTE: If the diverter valve is not
compatible with your faucet, you may
obtain an adapter. Contact your Rena
Ware representative or the Rena Ware
Customer Service Center for more
information.
5