RIB TOUCH Wi-Fi Manual Del Usuario página 17

2 - Make sure screw on steel cable clamp is tightened securely using
force (fig. 15).
3 - Make sure lever presses the central limit switch. If it does not, loosen
locknut that locks the adjuster and regulate the adjuster until the
castor reaches the proper position (fig. 16).
4 - Unscrew fastening screws of lower cover and remove it (fig. 2 - part.
2).
5 - Marks position (S) on upper side of fastening slot on the side of the
aluminum bar (fig. 2 - part. 3).
6 - Position TOUCH Wi-Fi on the wall and mark the position corresponding
to the reference marked previously. In cases of vertical assembly,
keep a minimum distance from the ground of 30 mm and aim the
device as shown in fig. 2 - part. 2.
7 - Perforate strip support surface about 7 mm under reference mark
and fasten retention spring with appropriate elements: screws for
metal or screws and anchor bolts for masonry (fig. 2 - part. 4).
8 - Position TOUCH Wi-Fi on retention spring and hook it by pulling it
downward.
9 - Mark fastening holes on wall in correspondence to -C- and -D- (fig.
2 - part 1 and 2).
10 - Remove device and drill fastening holes marked previously.
11 - Hook device to spring again and tighten screws.
9
11
13
Regulation check nut
Position the roller on central micro-switch pin
17
17
G
B
10
12
14
15
16