RIB TOUCH Wi-Fi Manual Del Usuario página 18

G
B
12 - Insert lower cover into notch and fasten with screws (fig. 17).
13 - Insert upper cover and fasten with screws.
14 - Check functioning of TOUCH Wi-Fi as described under the paragraph
of "CHECK PROPER FUNCTIONING".
I
DENTIFICATION
Each TOUCH Wi-Fi is supplied with microswitches in the OFF position
to prevent batteries from becoming discharged when not in use (if
connected).
Each TOUCH Wi-Fi must be ABSOLUTELY unequivocally identified by
putting only one of the six microswitches in the ON position (SW2).
Only one of the six microswitches must be in the ON position and the
identification must be different for each TOUCH Wi-Fi.
Note: IDENTIFY TOUCH Wi-Fi CONTAINERS BY APPLYING
NUMBERED ADHESIVE LABEL (SUPPLIED) ON OUTSIDE OF EACH
CONTAINER.
Identification of containers serves to rapidly replace dead batteries in
TOUCH Wi-Fi indicated by EDGE LED on MASTER Wi-Fi card.
EXAMPLE OF IDENTIFICATION OF A
TOUCH Wi-Fi STRIP ON A MASTER Wi-Fi
6
5
4
3
2
ON
1
MASTER Wi-Fi
M
EMORIZATION
After identifying the TOUCH Wi-Fi, put the microswitches corresponding
to the MASTER Wi-Fi in the ON position and memorize the codes of the
TOUCH Wi-Fi:
- Press the PROG RX key located on the MASTER Wi-Fi=> the bicolor
EDGE PHOT 1 LED will flash red for one minute (the time needed to
execute memorization).
- Press the PROG TX key on the TOUCH Wi-Fi with microswitches 1 set
to ON => on the MASTER Wi-Fi the bicolor EDGE PHOT 1 LED flashing
red will become green and a buzzer will signal that memorization of the
TOUCH Wi-Fi is correct, after which the bicolor EDGE PHOT 2 LED
immediately starts flashing red for one minute (time needed to execute
memorization) l.
- If other TOUCH Wi-Fi are not memorized, let one minute pass and the
bicolor EDGE PHOT 2 LED turns off; or press the PROG. RX key four
times to end the memorization procedure => all bicolor EDGE PHOT
EXAMPLE OF IDENTIFICATION OF 3 TOUCH Wi-Fi STRIPS
ON A MASTER Wi-Fi
6
5
4
3
2
1
TOUCH Wi-Fi 1 MASTER Wi-Fi
1 2
1 2
6
5
4
3
2
ON
1
TOUCH Wi-Fi 1
PROG RX
LEDs must be off.
18
18
Insertion
OFF
3 4 5 6
ON
3 4 5 6
6 6
5 5
4 4
3 3
2 2
1 1
TOUCH Wi-Fi 2 TOUCH Wi-Fi 3
BICOLOR LED 1
24V ac/dc
17
6
5
4
3
2
1