Publicidad
Idiomas disponibles
Idiomas disponibles
4. Attach
3%"
x 10" Damper/Duct
Connector
over
knockout opening. Make sure damper Pivot is nearest
to W/Back
EdgA of hood. Remove any shipping tape
from damper flap.
TOP/BACK
EDGE
3¼" x 10"
DAMPER/DUCT
CONNECTOR
PIVOT
5. Instal! Vent Cover over louvers at the front of hood. Insert
Tabs into top louvers, rotate cover downward, and snap
cover into bottom louvers.
VENT
COVER
/
TABS
6. Remove either top or back Wiring Knockout
and instail
approved Electricam Cabme Cmamja.
WIRING
KNOCKOUT
ELECTRICAL
CABLE CLAMP
Publicidad
