Setting Up Digi Connect Es Hardware - Digi Connect ES Serie Manual Del Usuario

Setting up Digi Connect ES hardware

Note While following the hardware setup procedure, refer to
1 Place the Digi Connect ES Device Server in a suitable location, noting the following warnings:
WARNING!
WARNING!
WARNING!
WARNING!
WARNING!
2 Powering the device on and off:
To power on the device:
a Attach the power cord to the Digi Connect ES Device Server (1).
b Turn on the power switch (2). The Power LED (12) illuminates.
To power off the device:
a Turn off the power switch (2). The Power LED (12) is no longer illuminated.
b Disconnect the power cord from the mains power connector.
Note Before cleaning or moving the device, turn off the power and disconnect the device from the mains
power connector.
3 Connect the device to the Network:
• Ethernet uplink port (5) for network: Use an Ethernet cable to connect the Ethernet uplink port (5)
to the network. The LED (8) illuminates if the connection is active and blinks if data is transmitted.
• Ethernet port 1 for hub or switch: On SW models, to connect the Digi Connect ES to a hub or switch,
use Ethernet port 1.
4 (Optional) On SW models, connect up to four additional Ethernet devices to the remaining Ethernet ports
(7). Make sure to use straight through Ethernet patch cables when connecting devices to the Digi Connect
ES Device Server Ethernet ports.
5 Connect serial devices:
Digi Connect ES Device Server Hardware setup guide
Mount the device server on a wall or place it on a tabletop away from high traffic areas. Keep
cables out of reach and off the floor.
To avoid risk of electric shock, this equipment must be connected to a supply mains with
protective earth.
Connect an optional grounding wire to the grounding stud (4).
Position the Digi Connect ES such that it is easy to insert and remove the mains power
connector and operate the power switch.
To disconnect the Connect ES from the AC mains, remove the power cord from the Connect ES.
Setting up Digi Connect ES hardware
Connectors, LEDs, and controls on page 11.
14