Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
• Clean all of the accessories that have been in contact with food, in
soapy water immediately after use.
• Improper use of the appliance and its accessories may damage the
appliance and cause injury.
• Handle the blade with great care. It is extremely sharp.
• To avoid all accidents and damage the appliance, do not use the
appliance for more than 5 minutes without interruption and leave it to
cool down for 40 minutes before using it again.
•
Check that your appliance's power supply rating corresponds to your mains electrical supply. Any error in
connection will cancel the terms of your warranty.
•
The power supply cord must never come close to or in contact with the rotating parts of the appliance, a source
of heat or sharp edges.
•
Do not immerse the appliance, the cord or plug or put them under running water.
•
Do not let the power cord hang down from the work surface.
•
Only use this appliance on a stable work surface, sheltered from splashing water.
•
Never let long hair, scarves, ties, etc. hang over the appliance when in operation.
•
Never disassemble the appliance. All you need to perform is normal cleaning and servicing.
•
Do not pull the power cord to disconnect the appliance.
•
Only use an extension cord if you have already checked that it is in good working order.
•
A household appliance must not be used
– if it has fallen to the ground,
– if it is damaged or incomplete.
Always use the slicer with its feed trolley (D) and its pusher (C).
•
•
For your safety, only use Krups spare parts made for your appliance.
•
After use, bring the slice thickness setting dial (F) back to minimum.
•
Caution: the blade will continue to turn for a few moments after each use.
•
Do not attempt to cut frozen food, bones, etc.
•
For your safety, this appliance complies with the applicable standards and regulations:
– Low voltage directive
– Electromagnetic compatibility
– The environment
– Materials in contact with food.
II - APPLIANCE DESCRIPTION
On/Off button
A
B
Safety button
C
Pusher
D
Feed trolley
E
Tray
Slice thickness adjustment dial
F
G
Platform
H
Blade
I
Unlocking button
J
Blade clamp screw
7
Publicidad
Tabla de contenido
