Inserting The Sintering Base - IDC T2 CoCr Modo De Empleo

5.6

Inserting the sintering base

▷ Insert the ceramic tube.
▷ Insert the floor plate.
Fig. 12
▷ Unscrew the six screws on the rear of the fur-
nace and remove the back panel.
Fig. 13
I N S T A L L A T I O N
▷ Thread the hose piece of the sintering base
through the hole of the rear wall and slide the
sintering base to the stop into the furnace; if
required, apply a light jiggling motion.
The hose piece must completely project out of
the rear side of the furnace.
Fig. 14
NOTE:
The tube can easily break when being bent.
▷ When mounting together, make sure to firmly
hold the sintering base by the connecting port.
E N
47