Electrical Connection - IDC T2 CoCr Modo De Empleo

Establishing the compressed-air connection
▷ Insert the compressed-air hose to the stop into
the service unit.
Fig. 22
▷ Connect the other end of the compressed-air
hose with the compressed-air connection in the
laboratory.
5.9

Electrical connection

The electrical connection is to be made via a
socket outlet with earthing contact providing 220-
240 V and 50-60 Hz. This socket outlet must be
located close to the furnace and be easily accessi-
ble.
When using an extension cord or a multiple socket
outlet, do not exceed the respective max. electri-
cal load rating.
I N S T A L L A T I O N
WARNING:
The mains cable may not be damaged!
▷ Do not place objects on the mains cable.
▷ Lay the mains cable in such a manner that
nobody can step on or trip over it.
NOTE:
Do not insert the mains plug before the heating
elements have been inserted.
▷ Set the mains switch to the 0 position.
▷ Connect the enclosed mains cable to the socket
intended for this purpose on the rear of the fur-
nace.
Fig. 23
▷ Connect the other end of the cable to the socket
outlet with earthing contact.
The mains cable may only be exchanged by an
approved identical one.
E N
51