Installation Of The Camera - Luda Elektronik trailerCam Guia Del Usuario

8. Installation of the camera

When installing the camera and especially trying out the correct positioning of the camera, we
recommended getting help from a second person. One person holds the camera in place and the other
views the monitor, until the correct angle is achieved.
1. Mount the small black antenna or the large antenna with cable on the backside of the camera. We
reccomend that you try using the small antenna first.
2. Turn off the power in the trailer. Connect the 12/24V power cable to a suitable power source.
Connect the horse shoe joint of the white-striped cable to the positive pole (+) and the horse shoe
joint of the black cable to the negative pole (-) of the power source.
-
+
12/24 V
3. Start the engine and turn on the power to the camera power source. Make sure that the camera is
supplied with power, the power indicator should be on.
4. Start the monitor. The image from your camera should show up automatically. If it doesn't please
go to the next chapter to pair the camera with the monitor.
5. When you are satisfied with the signal reception, mount the camera with the supplied screws. (Or
with the nuts and bolts depending on material)
The installation of your trailerCam-solution is now done!
Information
Sometimes the power source is not strong enough to feed the camera with enough
power. If you experience this we suggest you try another power source, or use our
battery pack accessory. (Art no. 152BAT)
If you run into problems with the installation, go to Troubleshooting, chapter 11.
Max 3 m
- 26 -