Mounting Procedure - Webasto SmarTemp Control 2.0 Instrucciones De Operación Y Instalación

SmarTemp Control
Thank you for choosing Webasto to meet your heating needs. The Webasto SmarTemp Control 2.0
enables you to quickly and effortlessly operate Webasto air heaters specified in the compatibility section.
Operation
The Webasto SmarTemp Control 2.0 is the next generation of the SmarTemp series controllers. It's
operated using a single rotary dial around the outside of the unit to scroll through menu options. Simply
click the select button (
Compatibility
AT 2000 ST/C - Adapter harness (P/N: 5010612)
AT EVO 3900/5500 & EVO 40/55 - Adapter harness (P/N: 5012138)

Mounting Procedure

Multiple factors such as doors and windows must be taken into consideration as they can directly affect
the SmarTemp Controls ambient temperature reading. Refer to "Temperature Calibration" section on
page 2 if these obstacles are unavoidable.
1. Find a suitable mounting location (on a flat surface if possible) in a visible area.
CAUTION: Always install the unit in an area protected from the effects of weather and dust
contamination or the unit will not function as intended.
2. Use the drilling dimensions / template in the back of this manual to
lightly mark the two mounting holes.
3. (Optional Step) To route wire harness through the mounting
surface, drill a 22mm hole as notated on the drilling dimensions /
template.
Note: Always make sure there are no obstacles behind the
mounting location prior to drilling.
4. Secure the Webasto SmarTemp Control 2.0 using the two supplied
#4 screws.
) to make your choice.
General
2
Installation - Operating Instructions