Urmet 1093/182WM1 Guía Rápida De Inicio página 11

After focusing and varifocal adjustment operations, tighten again the adjusting rings in
8.
order not to change the adjustments just performed.
It is advisable to install and configure one camera at a time if you are installing
9.
multiple cameras on the same network.
Connect the camera to the network (see section 4.1 or, alternatively, section 4.2)
10.
and assign a static IP address (see section 4.3).
Fix the protection dome to the vandal dome base, by screwing the three previously
11.
removed screws
It is advisable to check that the WiFi signal received by the camera is higher than
12.
or equal to 60.
Check that the framed area and the zoom level are correct and adjust the zoom
13.
on the LIVE web page of the camera, if needed. Then adjust the bracket again
and block it in its final position.
If you are using a NVR/HVR device, use the NVR/HVR menu to add the camera
14.
to the recording.
IMPORTANT NOTE: the SD card slot is for future developments and cannot be used.
4 ADDING THE CAMERA TO THE WIFI NETWORK
The camera can be configured on the WiFi network in two alternative ways: by temporarily wiring
it to the LAN (see Section 4.1) or in ACCESS POINT mode (see Section 4.2).
To configure the camera, copy the
the instructions shown in this guide.
Make sure that the PC is already connected (wire or wireless) to the network on which to
configure the camera.
IMPORTANT NOTE: The camera is provided with two different network boards, one for the wire
connection and one for the WiFi connection, each with its own MAC address and is own IP
address.
4.1 WIFI CONFIGURATION VIA CABLED NETWORK
Use a network cable to connect the camera to the LAN and power it. The camera will receive an
IP address assigned automatically by the DHCP service of the network. If the DHCP service is
not available on the network, the camera will automatically assign the default IP 192.168.1.168
to itself.
The following steps are needed for configuration:
"
1. Start EasyTool
mask, gateway and MAC address of each IP camera active on the LAN will be
automatically displayed, as shown in the figure below.
DS1093-559
"
EasyTool
"
on the PC by selecting
"
folder from the CD provided to your PC and follow
: the IP address, subnet
11