U.S.Robotics USR5461 Guía Breve De Instalación página 6

Step Two: Configure the Wireless MAXg Router
A. Launch a Web browser. In the location or address line of your Web browser, type
http://192.168.2.1 to access the Web User Interface. The Setup Wizard will be displayed.
Note: You may receive a "Page Not Found" error when you launch your Web browser. This is
a common experience. Close your browser window and relaunch it to correct this error.
B. Click Start to begin the Setup Wizard procedure.
C. Follow the on-screen instructions in the Setup Wizard to configure the basic connection set-
tings of the Wireless MAXg Router. For more detailed Setup Wizard instructions, refer to the
Installation section of the User Guide on the Installation CD-ROM.
Note: Refer to the Installation procedure in the User Guide on the Installation CD-ROM for more
detailed Setup Wizard information. Contact your ISP if you have any questions about your
Internet connection.
If your Internet Service Provider (ISP) uses a PPTP connection, you will need to perform the fol-
lowing steps to complete your Installation procedure and create an Internet connection. If you
have any questions regarding any of the connection settings, contact your ISP.
A. Perform the steps in the Installation Guide.
B. When the Setup Wizard is complete, launch a Web browser. In the location or address line of
your Web browser, type http://192.168.2.1 to access the Web User Interface. Log in using
the router user name and password you created.
C. Click the Internet tab and scroll down to the PPTP section.
D. Select the My ISP uses a PPTP connection checkbox.
E. Enter your Domain, User name, and Password. If your ISP uses a specific authentication
method, either select or deselect the appropriate checkboxes.
F. When you are finished, click Save. The router will restart and you should then have an Inter-
net connection. You can go to the Status page to view your connection information.
Step Three: Verify the Internet connection
When you are finished configuring the basic connection settings, you should have Internet
access. To confirm your connection, launch a Web browser and register your product at
www.usr.com/productreg If the page loads, you are finished with the installation procedure. If
the page does not load, refer to the Troubleshooting section.
Congratulations!
The installation procedure is now complete. You should now have shared
Internet access. If you experience any difficulties, refer to the Troubleshooting section of this
2