U.S.Robotics USR5461 Guía Breve De Instalación página 8

verify all of these settings, perform the following steps:
Windows Me, 98, or 95 Users: Click Windows Start and then Run. Type winipcfg and
click OK. Check the IP Address, Subnet Mask, Default Gateway, and DNS server data to
make sure they are correct. If the information is not correct, click Release All and then
click Renew All.
Windows XP, 2000, or NT Users: Click Windows Start and then Run. Type cmd and
click OK. At the DOS prompt, type ipconfig /all. Check the IP Address, Subnet Mask,
Default Gateway, and DNS server data to make sure they are correct. If the information
is not correct, type ipconfig /release and press ENTER. Then, type ipconfig /renew
and press ENTER.
Possible Solution:
If WPA encryption is selected, each wireless card or adapter must support WPA encryption. If you
are using a Wireless PC Card, PCI Adapter, or USB Adapter that does not support WPA encryption,
you will not be able to connect to the Wireless MAXg Router and will need to use WEP encryption.
Refer to the Configuration section of the User Guide on the Installation CD-ROM for information
on changing the security settings.
Possible Solution:
If you have a Static IP address and did not correctly enter the IP address, you will not be able to
connect to the Internet. If your ISP assigned you a Static IP address, make sure that you have the
correct IP address, Subnet Mask, and Default Gateway entered in the Internet area of the Web
User Interface.
My Wireless MAXg Router's Web User Interface is not responding, but I can still
access the Internet.
Possible Solution:
If your Web User Interface stops responding, unplug and then plug back in the power supply of
the Wireless MAXg Router. This will reboot the Wireless MAXg Router. If you are still unable to
4