First Use - LEGRAND 628 25 Manual De Instrucciones

Bloc autonome d'éclairage de sécurité sati adressable
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33

First use

Important :
Before switching on the AELUs, check that the remote control line is "open" on the control panel Cat. No. 628
00.
(See the Installing the system / Electrical connection of AELUs section in the instructions for the control panel).
• On power-up, the pilot light illuminates. The LEDs flash green/orange alternately for 30 seconds. Then only the
green LED flashes, or is lit continuously providing the batteries are sufficiently charged.
Note :
If the AELUs have been stored for an extended period, the LEDs will flash green/orange alternately until the bat-
teries are at the correct voltage.
Then only the green LED flashes, until the batteries are fully charged. It will then stop flashing and stay on conti-
nuously.
• After commissioning the AELUs, "close" the remote control line and check the wiring using the remote control but-
tons on the control panel.
TEST
19

Publicidad

Tabla de contenido
loading

Tabla de contenido