Dismantling And Reassembling The Pool - Trigano PISCINES 123 840 B Instrucciones De Montaje Y Guía De Utilización

 A heat-insulating sheet (incorporating small air liners or bubbles) will allow you to enjoy your pool to
the utmost, as it will heat the water, prevent heat loss during the night, prevent leaves and insects from
falling into the water, and prevent evaporation of the chlorine.
Filling and Emptying
You are recommended to fill the pool until the top of the skimmer is just above water level.
You are recommended not to drain the pool entirely. If you really do need to drain the pool completely,
do not do so during periods of strong wind, and do so as quickly as possible.
Your swimming pool is fitted with a material filtering system (sand filter, filtering skimmer, etc.) which
serves to eliminate debris such as insects, hair, leaves etc.
Chemical treatment is used in addition to the material treatment and is vital to keep your swimming
water clean.
In normal operating conditions, your swimming pool will need cleaning once a week. You may,
however, encounter occasional problems, which you will be able to put right by following the advice in
the table below.
PROBLEM
 Cloudy water
 Green water
 Slippery walls and floors
 Brown water
 Smell of chlorine
 Eyes and nose irritated
 Rough-feeling walls
 Line of black water
16 – Dismantling and reassembling the pool
You are strongly recommended not to dismantle your pool. However, if you really do need to do so,
proceed in the reverse order of assembly (this does not apply to semi-embedded and embedded
pools).
WARNING: If the pool is dismantled, the liner is no longer covered by the guarantee.
Take the following precautions when dismantling the pool:
Do not lift the liner while there is still water in the pool.
Empty the pool by siphoning with a pipe or using the purifier system.
CAUSE
Hard water with particles in
suspension.
Green water: formation or
growth of algae.
Brown water: presence of
organic matter.
pH level too high.
Chloramine content too high.
Hard water.
Grease and deposits on the
water line.
SOLUTION
Adjust the pH level.
Place a flocculant in the skimmer or
directly in the pool.
Backwash the filter (BACKWASH
position) until the water expelled
towards the drain is clean.
Brush the walls and the skimmer
basket.
Adjust the pH level.
Carry out shock treatment using a
suitable product.
Wash the filter.
Adjust the pH level.
Super chlorinate (shock treatment).
Backwash the filter (BACKWASH
position).
Remove deposits using a pool
brush or automatic pool vacuum
cleaner.
Clean the pool and remove scale
from the filter using
products.
Adjust the pH level.
Add a product to balance the
water's degree of hardness.
Clean the water line with a special
product.
Place a cartridge of flocculant in the
skimmer basket.
suitable
59 - Notice N°123 840 RevB