Battery Back-Up - THOMSON CR50 Instrucciones De Funcionamiento

SLEEP CONTROL
1. Press the STANDBY button to turn on the unit.
2. Press the TIME SET / SLEEP SET button to choose the Device-Sleep time from 90, 60, 30, 15,
10 and 5 minutes
3. The device will turn off after the displayed minutes from the minutes you selected.
4. To turn this off press the TIME SET / SLEEP SET button until the display shows "OFF".
TO SNOOZE
1. When you are wakened by the buzzer but wish to sleep for a few more minutes, simply touch the
"SNOOZE" button and it will turn the buzzer off for 9 minutes before the music or buzzer sound
again. This can be repeated.
TO LISTEN TO PRESET STATIONS
1. Set your desired frequency to be ready as a PRESET STATION.
2. Press the MEMORY button to enter PRESET SET-UP MODE.
3. P01 will blink. Press the MEMORY button again to set the current frequency as P01.
4. Repeat step 2 and step 3 until PRESET stations from P01 to P20 are set up.
5. Press the PRESET button listen to preset station P01.
6. Press the PRESET button again to move on to preset station P02, and do the same to reach other
preset stations.
7. To change the preset stations, repeat the steps above.
8. To restore default settings the device needs to be powered off.

BATTERY BACK-UP

Your clock has a battery back-up feature in case of power failure. 2 x AAA batteries (not included) are
required. You must insert the batteries to ensure that the battery back-up feature is ready in case of
power failure. If the power fails, the back-up battery will automatically continue operation of the clock
and maintain actual time. However, the display will not be lit. During actual power failure the alarm
function will not be operational. When electrical power is restored, the display will light up again and the
previously set alarm time is restored. The battery will maintain timekeeping for approximately 8 hours
during power failure or interruption.
NOTE: Remove the battery if the clock is to be unplugged for a long time to avoid unnecessary battery
drain.
Note the following information: Only use the power supplies listed below.
SPECIFICATIONS
Input: 220-240V~ 50/60Hz 15mA MAX.
Output: DC 5V 250mA
Frequency ranges: FM: 87.5 – 108Mhz
Clock Back-up: 2 X 1.5V, AAA, LR03
- EN 6 -