Part 2; Safety; Installation - Euronda Jolly Box Manual De Instrucciones

Before installing your Jolly Box read these safety instructions carefully. Failure to follow them could cause
malfunction or damage.
DO NOT PLACE THE DEVICE NEAR ANY HEAT SOURCE.
DO NOT EXPOSE THE DEVICE TO DIRECT LIGHT FROM WINDOWS OR LIGHT
SOURCES.
WHEN MOVING THE DEVICE BE CAREFUL OF ANY LIQUIDS IN THE
CONTAINERS.
TAKE SUITABLE CARE WHEN HANDLING DEVELOPING AND FIXING FLUIDS,
FOLLOWING THE MANUFACTURER'S INSTRUCTIONS.
After taking your Jolly Box out of the package, place it on a flat surface far from any sources of heat or light.
Remove the protective casing by lifting it off the base and fill the containers as follows: dilute the
concentrated solutions as indicated by the manufacturer, with water at a temperature of about 25°C to a
height of about 2 cm from the top of each container, and respecting the label indicating DEVELOPER and
FIXER. Fill with plain tap water, also at a temperature of °C the containers labeled WATER.
IMPORTANT: always place the water in the containers before the concentrated
chemical products. Stir well and cover the trays.

PART 2

SAFETY

INSTALLATION

14
Aquafilter
Jolly Box NA1015
JollyBox_Manuale_rev05 – 17/11/14