Install The Upper Handle - Craftsman 536.882650 Manual Del Usuario

HOW TO SET UP YOUR SNOW
THROWER
• Locate and remove container of 5W30 oil
and parts bag found in parts box.
• Remove top pallet from carton
• Cut and discard the plastic ties securing
the mid-chute rod and speed control rod
to the pallet, place them aside Discard
pallet
, Cut all four corners of the carton from top
to bottom and lay the panels flat
• Cut the bands holding the snow thrower
to the lower pallet,
ASSEMBLE SNOW CHUTE
• Remove back carriage bolt, see figure
below
Carriagem
Bolt
• Tilt chute back into operating 3osition
See figure below
Chute in
operating
position
Carriage-- _
Bolt
• Replace carnage boll
• Tighten carriage bolt securely. NOTE:
Check all bolts in chute ring for tightness,
• Remove and discard packaging used to
protect chute
INSTALL THE UPPER HANDLE
• Cut ties securing the clutch control cables
and remote chute control cable to the
lower handle. Lay cable away from
handles
• Remove the bolts securing the upper
handles to the lower handles See figure
below NOTE: Discard white plastic
washer used for shipping purposes on
the right side,
• Remove upper handle assembly and
place it into operating position Upper
handle should be on the outside of the
lower handle
NOTE: Unless you have the assistance of
another person, it may be easier to install one
side of the handle at a time
NOTE: Make sure the cables are not
caught between the upper and lower
handle
• Replace the bolts, flatwasher, Iockwasher,
and hex nuts removed earlier into the top
holes Do not tighten.
3/8' hex Nu_
J
318"Lockwasher
//,,Upper handle
Remove
J3/8 Flatwasher
}_3/8 X 2" Screw
• Install hardware supplied in parts bag
(screws, flatwashers, Iockwashers, and
hex nuts) into the lower holes
• Tighten all four bolts
• Replace protective caps onto screws in
upper holes