Petsafe MPA19-13800 Manual De Instalación página 15

5m.
Insert screw rods with hex nut completely through the
four outer screw holes on exterior frame until hex nut is flush
within screw hole.
Helpful Tip: Tape interior frame tunnel to exterior frame
inside flap opening to help hold frames together while inserting
screw rods.
5n.
Insert binder posts into four outer screw holes on interior frame
and align with screw rods. Be sure to insert binder post in screw
hole(s) inside battery compartment. Reach through flap
opening to push hex nut end of screw rod. While pushing hex
nut, use screw driver to tighten binder posts.
Helpful Tip: Pull interior frame slightly away from cut-out to
view screw rods and binder posts to help align.
Use a manual screw driver to tighten binder
posts. Do not over-tighten. Over-tightening can
strip installation hardware or warp the pet door
frame and prevent it from working properly.
www.petsafe.net
5m
5n
15