Control Panel; Loading The Ribbon Cartridge (Tear Bar Model) - Star SP200 Serie Manual Del Usuario

Control Panel

POWER ON LINE FEED
1 ON LINE switch
4 ON LINE lamp (Green LED)
3 POWER lamp (Green LED)
3 POWER lamp (green LED)
• Lights when the power to the printer is on.
• Flashes when paper is out, mechanical error occurs, when there is an alarm due to head
temperature detection, or when a CPU error has occurred.
• If the paper is out, load new paper and press the ON LINE switch.
• When the POWER lamp flashes due to occurrence of a mechanical error, turn off the power and
remove the cause of a mechanical error and then turn on the power again to reset the printer.
• If the POWER lamp flashes due to the alarm of the head temperature detection, the printer will
be set automatically when the head temperature becomes low.
4 ON LINE lamp (green LED)
LED lit: Printer is ON LINE
LED off: Printer is OFF LINE
LED flashes: CPU error
When the POWER lamp and ON LINE lamp light simultaneously, a CPU error has occurred.

Loading the Ribbon Cartridge (Tear Bar Model)

Cover
Power off
1 ON LINE switch
2 FEED switch
2 FEED switch
• When this switch is pressed and then released within
• When this switch is held depressed for more than 0.5
Switches the printer between ON LINE and OFF LINE.
ON LINE and OFF LINE switching is possible only
when paper is loaded in the printer.
0.5 sec., the paper feeds on line.
sec., the paper feeds continuously.
(The above paper feed operation is possible for both
ON LINE and OFF LINE modes.)
1 Turn off power to the printer.
2 Lift the cover up approx. 3 cm. Hold the cover
tilted at this angle, then pull it toward you to
remove it.
– 6 –