Loading The Paper (Tear Bar Model) - Star SP200 Serie Manual Del Usuario

Loading the Paper (Tear Bar Model)

Cover
FEED
switch
Roll paper
Positioning rib
Paper roll holder
Tear bar
FEED switch
1 Lift the cover up approx. 3cm. Hold the cover
2 Cut off the front edge of the roll paper
3 Confirm that the power of the printer is turned
Core
4 While observing the direction of the roll paper,
Axis
5 Move the paper roll holder in the direction of the
Paper roll holder
6 If the paper roll core has not been properly
Cover
Roll paper
7 Press the FEED (paper feed) switch to feed the
8 Insert the top edge of the paper into the tear bar
– 9 –
tilted at this angle, then pull it toward you to
remove it.
perpendicularly.
on.
insert the top end of the paper beneath the paper
guide as far as it will go. If the roll paper is installed,
the top end of the paper automatically comes out
from the paper exit.
arrow, and insert the roll so that the holes in the
core align with the axes of the paper roll holder.
Release the paper roll holder to secure the paper.
aligned with the paper roll holder, the cover
cannot to properly seated until the paper position
is corrected.
paper approximately 10cm.
slot, then mount the cover by reversing the
procedure for removing the cover in step 1
above.
Note: When the paper end mark appears on the
paper, replace the roll paper before it runs
out.