Publicidad
Idiomas disponibles
Idiomas disponibles
4,
Remove the hose by removing
the hose clamp. NOTE: The hose
clamp is not reusable. You must
purchase a new hose clamp,
see the Parts List or purchase a
standard hose clamp at a local
hardware store.
Hose Clamp
Regulator
Manifold
Remove pump mounting screws
securing pump (one on each side).
Pump Mounting
Screw
Pump
shown
moved
out
of
the way
Manifold
7.
Using an adjustable wrench or
5/8" wrench remove the regulator
manifold.
8.
Apply pipe sealant to new
regulator manifold and assemble,
tighten with wrench.
9.
Reapply pipe sealant to gauges,
quick connect, and safety valve.
10. Reassemble all components
in
reverse order of removal. Make
sure to orient gauges to read
correctly and use wrenches to
tighten all components.
6.
Carefully slide pump from
brackets and out of the way.
Before you store the air compressor,
make sure you do the following:
1.
Review the Maintenance section
on the preceding pages and
perform scheduled maintenance
as necessary.
2.
Set the On/Oft switch to "Oft" and
unplug unit.
3.
Turn the regulator counterclock-
wise and set the outlet pressure to
zero.
4.
Remove the air tool or accessory.
5.
Pull ring on safety valve allowing
air to bleed from the tank until
tank pressure is approximately
20 PSI. Release safety valve ring.
6.
Drain water from air tank by
opening drain valve on bottom of
tank.
_Risk
of Bursting.
--
Water will condense
in the air tank.
If not drained, water
will corrode
and weaken
the air tank
causing
a risk of air tank rupture.
7.
After the water has been drained,
close drain valve by turning
clockwise.
NOTE: If drain valve is plugged,
release all air pressure. The valve
can then be removed, cleaned, then
reinstalled.
8.
Protect the electrical cord and
air hose from damage (such as
being stepped on or run over).
Wind them loosely around the
compressor
handle.
9.
Store the air compressor in a
clean and dry location.
1000002888
16-ENG
Publicidad
