Installation Instructions - Danby DTT100A1WDB Manual De Instructions Pare El Uso Y El Cuidado De Su Unidad

Lavadora de doble tina
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Place of installation
Choose a place on a horizontal solid floor. If the
machine is installed on an unstable floor, heavy
vibration will result during spin.
Keep the machine body more than 5 cm apart
from the wall surface. If it comes into contact
vibration may occur.
Hose Installation
For your convenience, this washing machine is
equipped with a "Quick Connect" hose kit.
Please follow these instructions:
1. Connect the "faucet adapter" to your water
supply
2. Pressure fit the open end of the hose
assembly at least half way down the "water
inlet" nipple. No clamps are required to secure
this connection because it is not a pressurized
line application.
INSTALLATION INSTRUCTION
Faucet Adaptor
Quick connect
Water inlet nipple
3. Install the "quick connect" fitting to the faucet
adapter by pulling down the white collar. Pull
down on the white collar to disconnect.
4. For portable applications, avoid disconnecting
the water hose assembly from the "water inlet
nipple" connection. Always disconnect the
hose from the "quick connect" side. A "hanger
hook" is provided on the "quick connect" which
allows you to conveniently hang the hose on
the side of the cabinet.
Installing the drain hose
Install the drain hose properly as shown below.
Secure the drain hose to the drain outlet pipe,
using the clamp provided.
Hook drain hose over the edge of sink or
directly into your drain pipe.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido