Installation Instructions - Danby DWM028WDB-3 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS

LOCATION
• Do not use hot water. This appliance is for cold
water connection only.
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth. Do not spray the appliance
with water.
• Place the appliance on a level fl oor that is strong
enough to support it when it is fully loaded,
in a room that has convenient access to a
water supply and drain, has low moisture and
humidity and does not freeze in winter.
• Do not place the appliance on carpeted fl ooring
as this can block the lower ventilation openings.
• Keep the appliance away from heat sources and
out of direct sunlight. Excessive heat or sunlight
can deform or discolour the appliance.
• This appliance is intended for household use
only. It is not designed for outside installation,
including anywhere that is not temperature
controlled (garages, porches, vehicles, etc.).
• This appliance is 41 cm (16.2 inches) wide
by 74 cm (29.1 inches) high by 42 cm (16.5
inches) deep. Make sure that you leave the
minimum amount of space between the
appliance and all surrounding walls and vents.
Do not cover any of the ventilation openings
with any material as the appliance needs
adequate space to breathe.
• Allow 12.7 cm (5 inches) of space between the
back, sides and top of the appliance and all
adjacent walls.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
FEATURES
1. Lid
2. Water Inlet
3. Inner Tub
4. Lint Filter
5. Pulsator
6. Control Panel
7. Power Cord
8. Drain Hose
9. Adjustable Foot
1
4
ACCESSORIES
Water Inlet Hose Assembly
Base Plate
3
2
3
5
6
9
7
8

Publicidad

Tabla de contenido
loading

Tabla de contenido