decorflame MQCIHR-48CP Manual De Instrucciones página 2

OPERATION BY CONTROL PANEL
Plug the infrared heater into a 15 Amp, 120 Volt outlet.
The power switch is located at the rear panel of the infrared heater. Turn the power switch
to ON position. The unit will beep.
The heater is now controlled by the buttons on the control panel located at the front of
heater.
Press this button to turn ON the heater. The red indicator light will be on.
Press UP or DOwN button on the control panel to set the temperature
and the LED display indicates the temperature being selected. when
the desired temperature is reached, the heater will stop automatically.
when the temperature drops below the desired temperature, the heater
will turn ON automatically.
Press this button to switch between high and low heat. The red indicator
light will turn ON.
Press the clock button once, number "0" will appear on the LED display.
Press again to increase the time from 1 to 8 (e.g.: press the clock
button and set the time to "1", the heater will stop automatically after it
has been operated for 1 hour). The number "0" indicates that the heat
will operate continuously.
Press this button to switch between degrees Fahrenheit and degrees
°C
Celsius. The LED display shows the unit of measurement being selected.
°F
when the unit is switched off, the heater will keep working with air flow for a few seconds
to cool down the heater safely.
1500W
750W
when "E" appears on the display, it means that the temperature sensor may be loose.
First, turn off and unplug the unit. Check that the sensor located at the back of the unit is
firmly secured.
°C
°C
°F
°F
2
OPERATION BY REMOTE CONTROL
Press this button to turn ON the heater. The red indicator light will be on.
Press UP or DOwN buttons on the remote control to set the temperature.
The LED display on the heater indicates the temperature being
selected. when the desired temperature is reached, the heater will
stop automatically. when the temperature drops below the desired
temperature, the heater will turn ON automatically.
Press this button to switch between high and low heat. The red indicator
light will turn ON.
Press the clock button once, number "0" will appear on the LED display.
Press again to increase the time from 1 to 8 (e.g.: press the clock
button and set the time to "1", the heater will stop automatically after it
has been operated for 1 hour). The number "0" indicates that the heat
will operate continuously.
Press this button to switch between degrees Fahrenheit and degrees
°C
Celsius. The LED display shows the unit of measurement being selected.
°F
°C
750W/1500W
CLEANINg
warnInG: dISConneCt power and UnplUG the power Cord before atteMptInG any
MaIntenanCe or CleanInG to redUCe the rISk of fIre, eleCtrIC ShoCk or daMaGe
to perSonS.
Allow at least 10 minutes between turning off the unit and any maintenance or cleaning
to avoid the accidental burning of the skin.
Clean the unit by using a damp cloth. Do not use abrasive cleaners or spray liquids.
°F