Designers EDGE Instrucciones De Operación página 4

INSTRUCTIONS FOR WIRE SAFETY
GRILL INSTALLATIONS
WARNING: GRILL MUST BE INSTALLED ON WORKLIGHT BEFORE OPERATION
• The Wire Safety Grill has two attachment supports that are flexible and
two that are fixed. First install the two fixed fingers on the downward side
GRILL
of the worklight face in provided slots. Then bend the top two attachment
supports to slide into the provided top slots same as you did on the
bottom.
• Next there is a clip around the Safety Wire Grill that will hold the grill
firmly in place by putting the screw through the clips and into the face
frame of the worklight. Use a screwdriver to tighten safety grill screws
snug but do not over tighten.
• Next install the bulb in the floodlight after reading the bulb installation
instructions. Close the floodlight face with the screw. Carefully tighten the
screw, being sure to just snug up. Don't over tighten as it can stress on the
safety glass causing to break.
BULB INSTALLATION
INSTRUCTIONS
• If the lamp has been in use at the time it burns out give ample
time for the fixture to cool before attempting to change the bulb.
•For safety reasons always unplug the fixture from the outlet before attempting to change the
bulb. The switch could accidentally be turned on during this function and cause a potential life
threatening shock under the wrong conditions.
• First loosen the face screw/knob on the frame holding the safety glass and grill in place.
• To remove the old bulb push the bulb gently to the right until the left hand end slides easily out
of the socket. When installing the new bulb wear clean gloves or use a clean cloth to avoid getting
oil from your hands on the bulb. Insert the right end of bulb against
the right hand contact of the socket and push very gently until the left
hand end is free to come into contact with the left socket. Be sure both
ends of bulb are securely seated against both socket contacts. If bulb
comes into contact with your skin – clean with alcohol to remove any oil
residue.
• Now carefully replace the safety glass face of the fixture and tighten the
face screw/knob again firmly – but do not over tighten.
• Now your fixture is again ready for use. Plug in your fixture – being careful
not to point it in anyone's eyes. For safety always be sure you use a grounded
outlet for your 3-wire grounded lamp cord. If the fixture does not
work, push the on/off switch. (It may be in the off position).
WARNING: Never look at or point the fixture directly at anyone's eyes
as the bright light may damage sensitive eyes.
• The bulb life will vary due to handling of the fixture and voltage surges.
The bulb, therefore, cannot be warranted in any way. Using the fixture in a
horizontal position will extend the bulb life. Use of improper bulbs will void
your warranty on this fixture.