Designers EDGE Instrucciones De Operación página 5

WORKLIGHT SLED BASE ASSEMBLY INSTRUCTIONS
1. Tighten wing nuts on sides of worklight head so yoke is in
upright position. Position center hole in yoke over hole in crossbar
of sled base. From underside of crossbar slide black bolts through
hole in yokes. Tighten black nuts to secure yoke to sled base
(See Figure 1).
2. Your new fixture is ready to use after installation of bulbs and
grills. Be sure to follow all attached instructions regarding bulb
and grill installation.
TRIPOD ASSEMBLY INSTRUCTIONS (ONLY
SELECT MODELS COME WITH A TRIPOD)
• To assemble the tripod models, begin by loosening the black adjustment knobs on the tripod
legs. Slide the center pole through the adjustment sleeve and into bottom pole receiver. Tighten
receiver bolt so pole receiver is secure to pole. Tighten adjustment knob so legs stay fixed in
place. Now you are ready to install top portion of fixture (See Figure 1).
• Next mount the handle to the sled base with the screws/knobs included. (See Figure 2).
• Tighten wing nuts on sides of worklight heads so yoke is in upright position. Position center
hole in yoke over hole in crossbar. From underside of crossbar slide black bolt through hole in
yoke. Tighten screw/knob to secure yoke to crossbar. Repeat process for second worklight if your
model has twin heads. (See Figure 3).
Trouble Shooting
If light does not work check the following:
• Be sure you have power at the source and fixture is properly plugged into the power source.
• Be sure that bulb is properly installed and both ends of electrical contacts are against the con-
tacts on each end of the bulb.
• Bulb may have been damaged in shipment. Check lamp with another bulb or check bulb with a
continuity tester. If bad, replace bulb with a new bulb.
• Press RESET button on G.F.C.I. outlet (Not all models)
SAVE THESE INSTRUCTIONS!