Preparing For Use - H.Koenig GS8 Manual De Utilización

F. Driving Shaft (do not remove)
G. Motor Unit
H. Spout
I. Control Knob
J. Clamps
K. Pulp Container

PREPARING FOR USE

1. Ensure your glass or pitcher sits under the spout to collect the juice.
2. Place the pulp container into the appliance by tilting it forwards slightly. Insert the top end first and then
push down the bottom end.
3. Place the juice collector into the appliance. Make sure the rim is flush with the motor unit.
4. Put the filter in the juice collector. Ensure the filter is fitted securely onto the driving shaft. The blade should
sit below the rim of the pulp container when in place.
5. Hold the lid over the filter and lower it into position.
6. Snap the two clamps onto the lid to lock it in place (you will hear a click noise). Note. Ensure that both
clamps are secured properly.
7. Slide the pusher into the feeding tray by aligning the groove in the pusher with the small protrusion on the
inside of the feeding tube.
Control Knob. Off (O) – Low (1) – High (2)
8.