Power Switch; Loading Paper - 50 Dba (5050/5100) Cabinet Model And 55 Dba; (5050/5100/5180) Cabinet Model; Manual Paper Loading - Genicom 5000 Serie Guía De Referencia Rápida

POWER SWITCH

LOADING PAPER – 50 DBA (5050/5100) CABINET MODEL AND

Manual Paper Loading

5000 Series Quick Reference Guide
The power switch is located on the rear panel of the printer and is
marked "|" for on and "O" for off.
The power-on sequence, including self-test diagnostics, takes about
fifteen seconds at which point the operator display will show "On Line".
55 DBA (5050/5100/5180) CABINET MODEL
This printer is designed to use edge-punched (sprocket, or pin-fed)
fanfold paper. See "Appendix B - Paper Specifications," in the User's
Manual for further description of the types of paper that can be used in
the printer.
Printing without paper or using paper too narrow for the job may
damage printer components and void the printer warranty.
Full-width paper (14 5/8-inch or 371cm) should be used until the
operator is familiar with the printer's setup and operation.
For specific instructions on the 60 dBa cabinet model and the 52
dBa cabinet model, consult the User's Manual.
Unless otherwise noted, illustrations are of the 55 dBa (5050/5100)
cabinet model.
Power Switch
Fuse Holder
Power Connector
Caution
Note
11 GEK-99012D