Super Ego 186000000 Manual De Instrucciones página 22

Alignement
WARNING: Cut material can be thrown. Eyes can be
permanently damaged. Wear safety goggles.
Downstop adjustment: The downstop should be
adjusted so that maximum cutting capacity is
maintained and so that cut off wheel foes not hit
the sawbase or the surface which the tool is mounted
to.
1. Lower cutter head until the arm hits the
downstop.
2. Verify maximum cutting capacity and that there
is no contact between cut off wheel and base
or mounting surface.
3. If contact occurs, adjust downstop screw and
jam nut until problem is corrected.
NOTE: All other adjustments are described in the
"Basic saw operations" section.
Downstop
Assembly
Changing the blade.
1. Disconnect the machine from the power
cource.
2. Loosen the 3 screws (A), and remove the saw
blade cover (B).
3. Press in on arbor lock ( C) and at the same time
rotate blade (G) by hand until the arbor lock
engaged.
4. Using the 8 mm hex wrench provided, loosen
arbor screw (D) by turning it counter clockwise,
and remove arbor screw (D), washer (E), outside
wheel flange (F) and blade (G). Do not remove
inside blade flange.
22
5. Make sure the inside surfaces of both the inside
and outside blade flanges are clean and free
from any foreign substance.
6. Install new blade (G). Making certain teeth of
saw blade are pointing down at the front and
reassemble. Outside blade flange (F), washer (E)
and arbor screw (D). Turn arbor (D) clockwise to
tighten.
7. Replace saw blade cover that was remove in
STEP 2.
WARNING: Make sure arbor lock (C) is disengaged
and 8 mm hex wrench is removed before turning
on the power.
ENGLISH