Super Ego 186000000 Manual De Instrucciones página 26

Clean dust tank
Loosen the screw (A), take out the dust tank (B) and
clear it. Put the dust tank (B) dack and tighter the
screw (A) again.
Adjusting the stationary vise
The stationary vise can be repositioned by loosening
the adjustment bolts, sliding the fence to the desired
position and retightening the bolts. The maximum
width capacity is approximately 7-1/4" at 90º at 45º.
Changing the cutting anlge.
The vise be adjusted from 0º to 45º right.
1. Using the arbor wrench loosen the two bolts on
the vise, then set working surface on the vise at
the desired angle.
2. Tighten the two bolts.
26
Big blade guard and small blade guard
When the saw blade pressed down, the big blade
guard and small blade guard appropriately separate
to out the materials.
Prevent tremble device.
1. Set two screws on the saw blade guard which's
with support with oil inside.
2. To prevent the deviation occurred from
vibratility of
materials.
3. When the support been worn down please
set the two screws very tight, so it will work
effectly.
Workpice clamping
ENGLISH
saw blade when cutting