Mounting Options - LEGRAND HBEM3 Instrucciones De Instalación

MOUNTING OPTIONS

The HB350* can be attached either directly to the fixture surface
via the two screw holes provided in the Power Module or using the
HBNB3 back box and chase nipple. The Extender Module (HBEM3)
allows attaching the sensor to the side of the fixture in a number of
configurations using provided chase nipples.
HBNB3 back box mounting requires a standard 1/2" knockout for
the chase nipple. The box comes ready for side mounting. It can be
modified for rear mounting as follows:
1. Pop out the cap in the rear mounting hole.
2. Un-snap the chase nipple from the side mount and snap into the
rear mounting hole.
3. Use the cap from the rear mounting hole to close the side mount
hole.
4. The chase nipple provided can be pushed into a standard 1/2"
knockout in a metal fixture (max of 1 mm (0.04") thick metal)
without the need for an internal nut. A nut can be used for added
security if it is felt to be necessary.
5. The Power Module mounts to the back box with a bayonet type
fitting requiring a slight twist of the units to lock them into place.
HBNB3
Box
HB350*
Power
Module
HBLx
Lens
HBEM3
Extender Module
Rear
mounting
hole
HBNB3 Box
2
HBEM3
Extender
Module
Alignment Guides
Side of fixture
Bottom edge of fixture
HB350 Sensor Module
Lens below edge of fixture
Using the HBNB3 box with the
HBEM3 Extender Module