Teac WAP-8600 Instrucciones Rapidas página 12

ENGLISH
BRC stand and battery charge
The BRC contains a powerful rechargable Lithium Ion battery, which allows
many hours of wireless operation for the WAP-8600 system, due to high battery
capacity and the integrated power saving management of the BRC.
Before first wireless BRC usage, the battery requires recharging.
Connect the BRC power supply to the backside connector of the stand.
Place the BRC upright onto the charging dock stand. While standing there, the
charging bay connectors get in contact to the charging contacts at the BRC
bottom side and allow recharge of the rechargeable battery in the BRC.
The BRC can be operated while placed in the stand.
You can operate all functions while charging. Charging control even works when
switched to Standby!
Initial System Setup
By the following initial system setup, you will connect the BRC and the SMR to
each other and to your network and also do basic settings to prepare the
operation.
Please follow the below mentioned steps for connecting BRC and SMR:
● Power ON the SMR. The SMR will
boot and after apprx. 1 Minute it shows
flashing blue power indicator. This means
the SMR is in config mode and awaiting
the following settings.
● Power on the BRC. "Language
Setting" will be displayed. Select your
preferred language and follow the screen
instructions. After this procedure, the
BRC root screen welcomes you in your
selected language.
● Next, the time zone screen appears.
Select your time zone and confirm the
required daylight saving option for your
area.
● The wizard leads you to the "Search
SMR" screen, showing all SMRs that are
available for setup. To help identify the
SMR device, the default SMR name
contains the last 6 digits of its individual
MAC number. The MAC number of the
SMR you can find on its bottom label.
12