Routine Maintenance; Warranty And Contact Information - CPS PRO-SET CR700 Serie Manual De Operación

Sistema comercial de recuperacion de gas refrigerante de 1hp

Ocultar thumbs

Contenido

página de 21

/ 21
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

Filter Maintenance- the CR700 is equipped with a 100-mesh screen filter. This filter should be checked

periodically. A partially clogged filter will slow down the recovery rate of this unit.

Check the filter cartridge as follows:

• Use a 5/8" socket or boxed end wrench to loosen the suction port as shown in Figure 1.

• Once loose, remove the suction port- filter cartridge as shown in Figure 2.

• Either clean the current cartridge or replace with new cartridge.

• Inspect O-ring. Re-lubricate with compressor oil or equivalent.

• Place filter cartridge back into suction port fitting.

• Hand tighten this assembly back onto the CR700.

• Use a 5/8" socket or boxed end wrench to tighten 1/8 of a turn.

Do not over tighten, damage to the O-ring may occur.

• Check the connection for leaks.

Figure 1

WARRANTY AND CONTACT INFORMATION

CPS Products, Inc. guarantees that all products are free of manufacturing and material defects to the original

owner for one year from the date of purchase. If the equipment should fail during the guarantee period it will

be repaired or replaced (at our option) at no charge. This guarantee does not apply to equipment that have

been altered, misused or solely in need of field service maintenance. All repaired equipment will carry an

independent 90 day warranty. This repair policy does not include equipment that is determined to be beyond

economical repair.

(305) 687-4121; 1-800-277-3808 (U.S. only) Fax: (305) 687-3743

Ruby Industrial Complex, #06-10 Genting Block 80 Genting Lane,