Publicidad
Idiomas disponibles
Idiomas disponibles
Configuration by RJ-45 cable
1. Please plug your repeater appRP02V2 into a free electrical outlet in your
home that is within the coverage range of your primary router.
2. Connect the supplied RJ-45 cable between a LAN output from your
router and the repeater.
3. Follow the same steps as the wireless settings from point 3 to 5.
Note: If you cannot access your device do the following:
1. Click "Start, " "Control Panel", "Network and Internet", "Network
Connections" direct button click "Local Area Connection" or "Wireless
Network Connection", "Properties". Select "Internet Protocol Version 4 (TCP/
IPv4)" and click "Properties".
2. Enter 192.168.10.2 in the IP address, subnet mask 255.255.255.0 in and
gateway 192.168.10.1 in and accept.
3. Repeat the same steps as the wireless settings from point 3 to 5.
You can also restore the factory settings with the following procedure
below.
Connect the repeater to an electrical outlet (not strip), press the reset
button for 10 seconds and release, wait and do nothing, the repeater will be
returned to default values.
Configuration modes (setup wizard)
AP Mode (Access point)
1. Select AP within Wizard
12
Publicidad
