Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Become familiar with these terms
When the tank pressure drops to a
before operating the unit.
certain Iow level the motor wilI restart
CFM:
Cubic feet per minute,
automatically.
The low pressure
SCFM:
Standard cubic feet per
at which the motor automatically
minute; a unit of measure of air
restarts is called "cut-in" pressure.
delivery.
Cut-Out
Pressure:
When an air
PSIG:
Pounds per square inch
compressor
is turned on and begins
gauge; a unit of measure of pressure,
to run, air pressure in the air tank
Code Certification:
Products that
begins to build.
It builds to a certain
bear one or more of the following
high pressure before the motor
marks: UL, CUL, ETL, CETL, have
automatically
shuts off, protecting
been evaluated by OSHA certified
your air tank from pressure higher
independent
safety laboratories and
than its capacity.
The high pressure
meet the applicable
Underwriters
at which the motor shuts off is called
Laboratories
Standards for Safety.
"cut-out"
pressure.
Cut-In Pressure:
While the motor
Branch
Circuit: Circuit carrying
electricity from electrical panel to
is off, air tank pressure drops as
outlet.
you continue to use your accessory.
This unit is capable of powering the following accessories. The accessories are
available through the current Power and Hand Tool Catalog or full-line Sears
stores.
Accessories
In Line Filter
Tire Air Chuck
® Quick Connector Sets
(various sizes)
Air Pressure Regulators
Oil Fog Lubricators
Air Hose:l/4",
3/8" OR 1/2" LD. in
various lengths
Refer to the selection chart located
on the unit to select the tools this unit
is capable of powering.
This air compressor
pump is
capable of running continuously.
However, to prolong the life of your
air compressor,
it is recommended
that a 50%-75%
average duty
cycle be maintained; that is, the air
compressor
pump should not run
more than 30-45 minutes in any given
hour.
9-ENG
A10282
Publicidad
Tabla de contenido
